2 Front CV Axles for Lexus GX460 GX470 & Toyota 4Runner FJ Cruiser Tacoma

Two Front CV Axle Shaft Assemblies

Two front CV axle shaft assemblies for the specific Lexus GX and Toyota 4Runner, FJ Cruiser, and Tacoma applications listed below.

Critical fitment warning: Fitment varies by model, drivetrain, trim, engine, and production date. Toyota 4Runner coverage is limited to 4WD, and FJ Cruiser coverage is limited to 4.0L V6 4WD. Tacoma coverage has trim and build-date restrictions, but the source does not state its drivetrain or engine requirements. Confirm the VIN, drivetrain, engine, trim, production date, required front-left and front-right configurations, spline counts, compressed lengths, ABS tone-ring or encoder design, seal surfaces, mounting style, and original axle numbers before ordering.

Vehicle Compatibility

Lexus

• 2010–2022 GX460
• 2003–2009 GX470 — all models per source

Toyota

• 2003–2022 4Runner — 4WD only
• 2007–2014 FJ Cruiser — 4.0L V6, 4WD only
• 2005–2014 Tacoma — Base model only
• 2015 Tacoma — Base or TRD Sport only
• 2016–2020 Tacoma — vehicles built before 03/2020 only

Tacoma warning: The source does not provide engine or drivetrain restrictions for the listed Tacoma applications. Verify the VIN, trim, build date, original axle dimensions, and spline configuration. A 03/2020 production date is not the same as model year alone.

Reference Numbers

4343004070, 4343060060, 4343060080, 4343060081, 4343060082, NCV69170, 665235, 66-5235

Reference numbers are provided for comparison. Match them together with the VIN, vehicle configuration, dimensions, spline counts, seal surfaces, and original axle design.

Package Contents

• 2 front CV axle shaft assemblies

The source does not explicitly assign the two assemblies to left and right sides or provide separate dimensions for each position. Axle nuts, retaining clips, seals, intermediate shaft, support bearing, brackets, ABS components, transmission or differential fluid, and installation hardware are not confirmed unless shown in the product images.

Installation Notes

CV axle replacement affects steering, suspension, wheel-bearing retention, and drivetrain sealing; professional installation is strongly recommended. Compare both replacement axles with the originals before installation. Confirm side-specific length, spline count, inner-joint design, seal surface, ABS configuration, and any intermediate-shaft connection. Inspect wheel bearings, hubs, ball joints, control arms, tie rods, differential or front-drive unit seals, and related mounts. Use new axle nuts or retaining hardware where required, follow Lexus or Toyota torque specifications, refill any lost fluid with the specified type, and check for leaks. Do not allow the vehicle’s weight to rest on the wheel bearing with the axle loose. Complete an alignment check if suspension geometry was disturbed.

Frequently Asked Questions

How many axles are included?
Two front CV axle shaft assemblies are listed.

Are these confirmed as one left and one right axle?
The source confirms two front assemblies but does not explicitly assign left/right positions. Compare each axle with the original parts and product images.

Does this fit a 2WD 4Runner or FJ Cruiser?
No. The listed 4Runner and FJ Cruiser applications require 4WD.

Does this fit every 2016–2020 Tacoma?
No. The source limits coverage to vehicles built before 03/2020, and engine/drivetrain requirements are not provided. Verify the VIN and original axle specifications.