A/C Compressor with Clutch for 2008-2012 Honda Accord & 2012-2015 Crosstour 2.4L

A/C Compressor with Clutch for Honda Accord and Crosstour 2.4L

Belt-driven 10SR15C air-conditioning compressor with clutch for the specific Honda 2.4L four-cylinder applications listed below.

Critical fitment warning: Fitment is limited to 2.4L L4 applications. The source does not specify Accord Sedan versus Coupe, Crosstour drivetrain, trim, transmission, production date, or compressor reference numbers. Confirm the VIN, engine, body style, drivetrain, original compressor label, mounting ears, refrigerant ports, electrical connector, clutch design, pulley diameter, and groove count before ordering.

Vehicle Compatibility

• 2008–2012 Honda Accord — 2.4L L4
• 2012–2015 Honda Crosstour — 2.4L L4

V6 and other engine applications are not confirmed. Accord body-style coverage and Crosstour drivetrain restrictions are also not provided by the source.

Specifications

• Compressor type: 10SR15C
• Clutch: Included per source
• Refrigerant: R134a
• Oil type: PAG 46
• Oil prefill: 150 mL
• Pulley diameter: 130.5 mm
• Pulley grooves: 7

Oil-charge warning: Do not assume the stated prefill is the correct final system oil quantity. Measure and compare the removed compressor oil, account for any flushed or replaced components, and follow the applicable Honda service information to set the total oil charge. Too much or too little oil can damage the compressor or reduce cooling.

Package Contents

One A/C compressor with clutch. O-rings, seals, manifold hardware, refrigerant, additional oil, receiver-drier or accumulator, expansion valve, condenser, drive belt, and installation hardware are not confirmed unless shown in the product images.

Installation Notes

A/C service requires refrigerant recovery equipment and should be completed by a qualified technician. Diagnose the cause of the original compressor failure before installation. If internal debris or contamination is present, follow the applicable Honda service procedure for flushing or replacing affected components; some modern condensers cannot be reliably flushed. Replace required seals, lubricate O-rings with the specified oil, verify the oil balance, rotate the compressor by hand as directed, evacuate the system, leak-test it, and charge the exact vehicle-specified mass of R134a. Confirm correct clutch operation, belt alignment, system pressures, vent temperature, and absence of leaks or abnormal noise.

Frequently Asked Questions

Does this fit a V6 Accord or Crosstour?
No V6 fitment is confirmed. This listing is limited to the stated 2.4L L4 applications.

Does this fit both Accord Sedan and Coupe?
The source does not specify body style. Verify the VIN and match the original compressor label, mounting points, ports, connector, and pulley.

Is oil already inside the compressor?
The source states 150 mL of PAG 46 oil is prefilled. The installer must still calculate and set the correct total system oil charge.

Is refrigerant included?
Not confirmed. The system must be evacuated and charged with the vehicle-specified amount of R134a using proper service equipment.