Front Left CV Axle for 2015-2017 Honda Accord 2.4L Manual & 2007-2014 CR-V

Front Left CV Axle Shaft Assembly

Front-left, driver-side CV axle shaft assembly for the specific Honda Accord and CR-V applications listed below.

Critical fitment warning: The 2015–2017 Accord application is limited to the 2.4L L4 engine with a manual transmission. Automatic and CVT Accord applications are not confirmed. For the 2007–2014 CR-V, the source does not specify engine, 2WD or AWD, transmission, trim, production date, ABS configuration, inner and outer spline counts, compressed length, seal-surface diameter, inboard joint design, or intermediate-shaft connection. Confirm the VIN, front-left position, engine, transmission, drivetrain, original axle number, spline counts, compressed length, ABS design, seal surface, and inner-joint configuration before ordering.

Vehicle Compatibility

• 2015–2017 Honda Accord — 2.4L L4, manual transmission only, front left / driver side
• 2007–2014 Honda CR-V — front left / driver side; engine, transmission, and drivetrain restrictions not provided

Not confirmed: Accord automatic or CVT applications, Accord engines other than the stated 2.4L L4 manual configuration, and any CR-V configuration that does not match the original axle references and dimensions.

Reference Numbers

44306SWA900, 44306SXSA10, 44306T0AA01, 44306T2AA71, NCV36574, 664256, 66-4256

Reference numbers are provided for comparison. Match them together with the VIN, engine, transmission, drivetrain, axle dimensions, spline counts, seal surface, ABS configuration, and inner-joint design.

Position and Quantity

• Axle: Front
• Side: Left / driver side
• Quantity: One CV axle assembly

Package Contents

One front-left CV axle shaft assembly. Axle nut, retaining clips, seals, intermediate shaft, support bearing, brackets, ABS components, transmission or differential fluid, and installation hardware are not confirmed unless shown in the product images.

Installation Notes

CV axle replacement affects steering, suspension, wheel-bearing retention, and transmission or differential sealing; professional installation is strongly recommended. Compare the replacement with the original before installation, including overall and compressed length, inner and outer spline counts, joint and seal-surface diameters, ABS configuration, and inboard connection. Inspect the wheel bearing and hub, ball joint, control arms, tie-rod end, transmission or differential seals, and engine/transmission mounts. Use a new axle nut or retaining hardware where required, follow Honda torque specifications, refill any lost fluid with the specified type, and check for leaks. Do not allow vehicle weight to rest on the wheel bearing while the axle is loose. Complete an alignment check if suspension geometry was disturbed.

Frequently Asked Questions

Does this fit an automatic or CVT Accord?
No such fitment is confirmed. The source specifies a 2.4L L4 Accord with manual transmission only.

Does this fit both 2WD and AWD CR-V models?
Drivetrain coverage is not stated. Verify the VIN, original reference, inboard joint, length, and spline counts.

Which side does this fit?
This is for the front-left, or driver-side, position.

Is an axle nut included?
Not confirmed. Review the product images and obtain any required single-use hardware before installation.