Power Steering Pump for 2002-2009 Toyota Camry & 2002-2008 Solara 2.4L

Power Steering Pump for Toyota Camry and Solara 2.4L

Replacement power steering pump for the specific Toyota Camry and Solara 2.4L four-cylinder applications listed below.

Critical fitment warning: This pump is limited to the stated 2.4L L4 applications. Confirm the vehicle uses a belt-driven hydraulic power-steering system and not an incompatible steering configuration. The source does not specify pulley inclusion, pulley diameter or groove count, reservoir inclusion, pressure-switch or sensor provision, inlet and outlet fitting dimensions, mounting bracket, operating pressure, flow rate, or required fluid. Compare the VIN, engine, original pump number, mounting points, hose fittings, shaft, pulley, and reservoir configuration before ordering.

Vehicle Compatibility

• 2002–2009 Toyota Camry — 2.4L L4
• 2002–2008 Toyota Solara — 2.4L L4

V6 applications and engines other than the stated 2.4L L4 are not confirmed.

Reference-Number Warning

The source description lists 21-5495 and 2055982. The product’s internal SKU contains a different number, 21-5245. Because these values conflict, do not treat them as interchangeable without verification. Match the VIN, original pump label or casting, mounting pattern, hose ports, shaft, pulley, and reservoir configuration before purchase.

Package Contents

One power steering pump. Pulley, reservoir, cap, mounting bracket, pressure switch or sensor, hoses, O-rings, seals, mounting bolts, drive belt, and power-steering fluid are not confirmed unless shown in the product images.

Installation Notes

Steering-system service is safety-critical and should be completed by a qualified technician. Diagnose the full hydraulic system before replacing the pump; noise or heavy steering can also result from low or incorrect fluid, air, a slipping belt, restricted hoses, leaks, a damaged reservoir screen, or steering-rack problems. Compare the replacement pump with the original, transfer only approved reusable components, replace disturbed seals, and use the Toyota-specified fluid. Flush contaminated fluid, avoid running the pump dry, follow the correct bleeding procedure, and turn the steering slowly without holding it against either stop. After installation, check belt alignment and tension, inspect all connections for leaks, confirm quiet operation and consistent steering assist, and recheck fluid level after the system is free of air.

Frequently Asked Questions

Does this fit V6 Camry or Solara models?
No V6 fitment is confirmed. The source specifies 2.4L L4 applications only.

Is the pulley included?
Not confirmed. Review the product images and compare the shaft and pulley configuration with the original pump.

Is the reservoir included?
Not confirmed. Verify the product images and original system layout.

Which reference number should I use?
The source and SKU contain conflicting numbers. Verify the VIN and physical pump configuration rather than ordering by one number alone.